Troubleshooting of sweeper and scavenger

　1. No suction ability
The cabin full of garbage discharged waste
The suction or Straw blocking up clogged garbage
After the door is not closed after the door closed
The hydraulic coupler fusible plug replacement melt fusible plug, in accordance with the regulations and oiling
The suction cover is not open






2. The absorption of suction is weakened
The vacuum tube part blocking up clogged garbage
The slipping of belt tensioning wheel receiving
The other side of the suction cover does not cover tightly repair, adjustment
The other side suction hose mouth without cover and cover
The dustbin after partial obstruction of clean filter
No fan adjusting ring position offset is adjusted according to the requirements of the new
To reduce the amount of oil, hydraulic coupler, fan speed according to the slip 3-4% claim amount of fuel (5.6L)
Therefore, the fan entrance damaged seals, replace the seal leakage
Vice, engine speed is not correct, the slow speed of adjustment according to the requirements
That rear door sealing strip is damaged, replace the seal leakage






3, secondary machine ignition difficulty
The three inspection should not fuel tank fuel Chuche
The fuel line with air exhaust air
The position does not return flameout inspection and maintenance
The ignition oil supply is not the ignition timing adjustment oil supply angle






4, auxiliary engine starter stop
The battery without electricity for battery or charging
The battery connect bad check and repair
The ignition switch failure check and repair
The failure to start checking, motor repair






5. The auxiliary engine starts but does not speed up
The adjustment cylinder stuck to check and repair
The adjustment of wire rope off the check and repair
The lack of air pressure adjustment provisions check air pressure, according to
The intake pipe or filter clogging up






6. The water temperature of the engine is high
The water tank maintenance Water Leakage place
The three inspection should be insufficient engine oil before driving
The engine cylinder pad so to replace the cylinder pad
The failure to open check replacement thermostat






7. The speed of the side brush is low
The auxiliary engine rotational speed check adjustment
The hydraulic coupling transmission oil is too small, the slip increases add oil according to the provisions
The hydraulic system leak check and repair
The hydraulic oil temperature is too high to check the reasons






8. The side brushes do not turn
The pump shaft connector bolt replacement
The fault diagnosis of hydraulic motor repair
The fault check valve repair






9. The side brush can not be locked after recovery
The lifting wire length is not suitable to check and adjust, in improving the position should be a little activity
The lock cylinder fault check and repair